We have found 2 mistakes in the Golfer Instructions/Parts Diagram.
Paragraph 16 – The first sentence should read: Glue 27mm x 3mm diam peg into the “T-Lift Block” so that the end is level with the surface on the other side, instead of “T-Lift “
In the parts diagram, the sides are labelled as back/front and therefore the back/front are labelled as sides. The side have the holes drilled for the crank shaft.
I am building the Golfer and have found that the bottom of the legs are cut at an angle to the feet. The holes in the feet are drilled square, so they do not fit flush with the bottom of the legs. I have dry assembled the legs with all parts including the 6mm rod.
Also, the 164 mm X 3mm rod is shown as 163mm long in the guide to pieces, but is actually cut to 161mm. I have cut a new one (164mm)from a kebab skewer, but am not sure which is the correct length.
This is the third model which I have built and so far have been amazed at the finish and detail of such small wooden pieces. Thanks, Roger O'Neill
Golfer Instructions
Posted - 11/12/2008 : 10:32:17 AM
